Mountain Highbay Sensor Remote Control - White

Description

Description
This is the handheld controller that goes with the Mountain highbay range, and it does one useful job: it puts every sensor setting on a printed keypad you can hold in one hand. The handset is white with grey keys and a tapered head. Reading down the panel, there are two rows of percentage levels from 10% up to 100%, time rows running from 5s through to 30m, a further timing row that ends in a continuous symbol, and a row of light-level values from 5L to 150L with Disable and Override DH beside them.

It earns its place wherever the fittings are mounted too high to reach comfortably. In a warehouse aisle, a workshop, a stockroom or a loading bay, changing how a sensor behaves usually means getting a ladder out for every fitting in the run, which is why so many sensors are left on whatever they came set to. A handset moves that job to the floor. It suits an installer commissioning a whole row in one visit, and it suits the facilities person who comes back months later because the traffic through an aisle has changed and the lights are dropping to standby before anyone has finished working.

The keypad is grouped rather than listed, which matters when you are working one-handed. A red ON/OFF key sits with Reset, Sensor Motion and DIM Test; DIM+ and DIM- flank DH Mode on the row below; QS1, QS2 and QS3 come next, then HS, LS and TEST 2S. Above the printed panel is a sliding switch marked 5m, 10m and 15m. We have no ingress protection rating from the manufacturer for this handset, so we do not claim one, and no battery information is published either. It arrives as one handset and the minimum order is one, so buy a spare only if you want a second.

Specification

Type
Handheld controller for highbay sensor fittings

Finish
White body with grey keys and one red ON/OFF key

Controls
ON/OFF, Reset, Sensor Motion, DIM Test, DIM+, DIM-, DH Mode, QS1, QS2, QS3, HS, LS, TEST 2S, plus printed preset rows and a sliding switch marked 5m, 10m and 15m

Dimmable
Yes. Dim up and dim down keys with preset levels from 10% to 100% are marked on the keypad

IP rating
Not stated by the manufacturer

Sold as
One handset

Minimum order
1, sold in multiples of 1

Frequently Asked
Will this handset work with any highbay sensor?

It is supplied as the controller for the Mountain highbay range, and no wider compatibility list is published, so tell us your fitting and we will check the pairing before you order.

Can I dim the lights with it?

Yes. The keypad carries dim up and dim down keys, a DIM Test key and printed preset rows running from 10% up to 100%, so levels can be set as well as nudged.

What powers the handset, and are cells included?

The manufacturer publishes no battery information for this listing, so we will not guess at the type or say whether cells are supplied. Ask us and we will get it confirmed.

Is it rated for damp or outdoor sites?

No ingress protection rating is published for the handset, so we make no claim at all. Treat it as an unrated accessory and ask us first if the site is exposed.

What do the QS, HS and LS keys do?

Those keys are printed on the keypad but no key legend is supplied with this listing, so we will not interpret them. We can request the programming sheet from the manufacturer for you.

How many do I receive, and is there a minimum order?

One handset per unit, and the minimum order is one, sold in multiples of one. Most sites need a single handset kept with the maintenance keys.